http://www.tnthobbiesonline.com/
« previous next »
Pages: [1]

Author Topic: CNC Aluminum Head  (Read 139 times)

0 Members and 1 Guest are viewing this topic.

Crop Duster

  • Trade Count: (0)
  • Forum Newbie
  • *
  • Posts: 23
  • Forum Newbie
CNC Aluminum Head
« on: May 26, 2010, 10:59:43 AM »
I have a Trex 450 and i tore it up before i got it off the table but anyway ive purchased all alighn replacement parts except the rotor head which i purchased a blue looking aluminum cnc head and the gap for the blades are wider. Is there parts out there to fix this problem or should i just by the original stuff.

Crop Duster  :dontknow
Logged

Valkyrie_1520

  • Trade Count: (9)
  • Hero Member
  • *****
  • Posts: 533
  • Old enough to know better.....
Re: CNC Aluminum Head
« Reply #1 on: May 26, 2010, 11:02:16 AM »
You can use small washers to tighten up the gap. I use aluminum rivet washers that are available at any hardware store.
Logged
Tim

JR 12X 2.4Ghz DSM2 ;D  AMA#495339

Crop Duster

  • Trade Count: (0)
  • Forum Newbie
  • *
  • Posts: 23
  • Forum Newbie
Re: CNC Aluminum Head
« Reply #2 on: May 26, 2010, 11:05:38 AM »
This is good 1/4" gap when i install the blades


Crop duster
Logged

Valkyrie_1520

  • Trade Count: (9)
  • Hero Member
  • *****
  • Posts: 533
  • Old enough to know better.....
Re: CNC Aluminum Head
« Reply #3 on: May 26, 2010, 11:10:59 AM »
WOW! Where did the head come from? Was it a stock replacement for the 450?
Logged
Tim

JR 12X 2.4Ghz DSM2 ;D  AMA#495339

Crop Duster

  • Trade Count: (0)
  • Forum Newbie
  • *
  • Posts: 23
  • Forum Newbie
Re: CNC Aluminum Head
« Reply #4 on: May 26, 2010, 09:42:44 PM »
Got it at A-Main i think but it was really reduce in price and i guess thats why

Crop Duster
Logged
Pages: [1]
« previous next »